Spool Holder Attachment

The days of treading on wet, muddy, twisted, tangled welding rod that was a pain in the neck are over! 

• In seconds, the Spool Holder component snaps into place on the extrusion welder drive motor housing.
• The welding rod spool is attached to a hub that spins smoothly on bronze bushings that self-lubricate.
• The small spool is held in place by a fast release shaft collar, which allows it to spin freely.
• Simply attach any drill to the shaft’s end and load up to 6.5 pounds of 4 or 5 mm welding rod onto Demtech’s smaller spools from conventional 15 to 30 pound spools.
• For a continuous, hassle-free operation, the extrusion welder feeds rod directly from the spool.